Tough N' White Primer

  Sculptural Arts Tough N' White Primer is a full-bodied, water-based, Non-Toxic, fast drying, primer-sealer with outstanding adhesion, designed to give scenic materials the best protection available. It is ideal for use under water-based or oil-based top coats and on interior or exterior surfaces, both new and previously painted.

Directions
Porous Surfaces Masonry Surface Prep Tinting Compatibility
Application Coverage Dry time Clean Up Cautions

Material Safety Ratings of Health 1, Flammability 0, Reactivity 0, Personal Protection 0. These Safety ratings make Tough N' White Primer ideal for use in all types of shops and SAFE for working with volunteers and children.

Porous Surfaces- New wood, foams, plywood, muslin, cured plaster, drywall and painted surfaces will be well sealed and primed so that the top coat goes on easier, looks better, and lasts longer. Once primed, top coats then have better coverage, gloss retention, brighter color, and hiding power.

Masonry- Stucco, Concrete, Brick; - Tough N' White Primer fills and seals in one coat, creating an excellent surface for the finish coat. Less finish paint is required. Mortar and concrete must be fully cured prior to application.

Surface Prep- All surfaces must be clean and free of oil, wax, dust, peeling paint and loose wallpaper. If surface is extremely dirty or chalky, wash with a stiff brush and water. Clean mildew with a solution of 3 parts water to 1 part bleach. Check for unsound paint by cutting an "X" into the paint with a razor. Firmly press scotch tape over the mark and yank it quickly away. If paint releases, it is unsound and should be removed.

Compatibility - Tough N' White Primer can be used over any latex paint and can be top coated with any latex or alkyd finish paint.

Tinting-May be tinted toward the top coat color with Artist's Choice Saturated paints or water based universal tinting colors.

Application-Tough N' White Primer may be applied by brush, roller, pad applicator or sprayer. Do not apply below 50F.

Coverage - Up to 400sq. ft per gallon depending on the porosity of the surface.

Dry Time- Under normal conditions, dry to handle in 30-40 minutes. May be top coated in 1 hour. Low temperatures, high humidity, poor ventilation, may increase drying time. Use a shop or box fan to speed up drying time if needed.

Clean up- Use warm water and soap to clean tools and equipment.

Cautions - Use adequate ventilation. * Close container after each use * Do not apply when surface or air temperature is below 50F. * Store between 40F - 100F. * Do not take internally. *Avoid breathing Spray mist. * Keep from freezing.

Warranty - Directions are as complete as possible, but cannot encompass all conditions, applications, techniques and/or surfaces which are beyond our control. The user must determine the suitability of this product for his or her particular application(s) and accepts full responsibility of that determination and responsibility for any consequential damages should they arise. The Manufacturer and Seller make no warranties expressed or implied and accept no responsibility other than replacement of product.

 

Do not mix this water based primer with oil based paints.

© Sculptural Arts Coating, Inc.

800-743-0379 * www.sculpturalarts.com

Back to top